SILICON STAR INTERNATIONAL, INC.

SC3210V VL-BUS SCSI

Data bus:                32-bit VESA
Size:                    Full-length, half-height card
Hard drive supported:    up to fourteen SCSI Interface drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                           CONNECTIONS

                  Function                        Location

  34-pin connector - Floppy drive interface          J1

  50-pin SCSI connector - internal                   J2

  50-pin SCSI connector - external                   J3

  4-pin connector - drive activity LED               JW1

                        USER CONFIGURABLE SETTINGS

               Function                    Location           Setting

  »   Floppy drive controller at 3FX          JP1              open
      address enabled

      Floppy drive controller                 JP1             closed
      disabled

  »   Hard drive controller address           JP2              open
      set at 17X

      Hard drive controller address           JP2             closed
      set at 1FX

  »   ROM address set at C800:0               JP3              open

      ROM address set at D800:0               JP3             closed

  »   VESA mode enabled                       JP4              open

      ISA mode enabled                        JP4             closed

  »   Factory configured - do not             JP5               N/A
      alter

  »   Factory configured - do not             JP6               N/A
      alter

  »   Factory configured - do not             JP7               N/A
      alter

  »   Floppy drive controller set at         JP13             closed
      DRQ2

      Floppy drive controller DRQ            JP13              open
      disabled

  »   Floppy drive controller                JP14             closed
      address set at IRQ6

      Floppy drive controller IRQ            JP14              open
      disabled

  »   Hard drive IRQ set at IRQ 15           JP15            pins 2 & 3
                                                              closed

      Hard drive IRQ set at IRQ 14           JP15            pins 1 & 2
                                                              closed

  »   Floppy drive controller set at         JP16             closed
      DACK2

      Floppy drive controller DACK           JP16              open
      disabled

                       MISCELLANEOUS TECHNICAL NOTE

  Note:When connecting additional SCSI devices, the user must make sure
  that proper termination is used on both ends of the SCSI bus. This
  controller is factory-configured to be the first SCSI device on the
  SCSI bus. Termination is supplied by resistor packs RP3, RP4, and RP5.